Australian Decarboxylator & Oil Infuser Manual

⚠️ Safety Precautions

Do Not Open During Operation
Opening the lid mid-cycle can disrupt the process and may expose you to hot surfaces. Always allow the cycle to complete before opening.
Low Odor & External Heat
It's normal for the machine to emit little to no odor and feel cool or only slightly warm during operation. This indicates efficient, low-emission decarboxylation.
Dry Material Only
Use only dry botanicals for decarboxylation. Do not add liquids or solvents during this process.
Not a Medical Device
This appliance is not intended to diagnose, treat, cure, or prevent any disease. It has not been evaluated by any medical regulatory authority.
Handle with Care
The internal container and contents may be hot after use. Allow to cool before handling.
Avoid Water Contact
Do not immerse the base, cord, or plug in water or any other liquid. Always unplug when not in use.
Keep Away from Children
This is an electrical appliance. Do not leave it within reach of unsupervised children.
Lid Must Be On
Always operate the unit with the lid securely in place. Use only as directed.

Unbox and Position
- Place the unit on a flat, dry surface away from water, pets or children.
- Plug in the device. The screen will display “--:--” indicating readiness.
Load the Botanicals
- Twist off the top white lid and remove the inner green silicone insert.
- Add up to 1 oz of dry botanicals or 3–5 oz of concentrates. we recommend breaking them into small pop corn parts; stems are acceptable.
- Put the green lid on and pop the green insert back into the unit, followed by the white lid.

Power On
- Tap the Power (⏻) button. The default screen will appear.
Set Time
- Press the time button and use ▲ or ▼ to adjust the time (click here for our recommended times and temps).
Set Temperature
- Press the temp button and use ▲ or ▼ to select your desired temperature (71°C to 121°C / 160°F to 250°F).
- Helpful hint: Hold the temp button for 3 seconds to switch between °C and °F.
Start Cycle
- After 3 seconds of inactivity, the machine will begin.
- The display will alternate between the actual temperature and remaining time while in operation.
Cooling Phase
- After decarbing, the machine will cool for 15 minutes automatically.
- A soft "di" tone and animated display indicate the cycle is ending.
Finish
- When complete, the screen will show “End” and beep for 1 minute before shutting down.

Prepare Your Infusion
- Leave your decarbed herb in the green silicone insert and add in your oil or butter.
- Put the lid back on and pop the green insert back into the unit.
Set Infusion Settings
- Follow the same steps to set your infusion time and temperature.
- Recommended: 71°C (160°F) for 2-4 hours.
Cool, Strain & Store
- After infusion, allow the mixture to cool.
- Strain using cheesecloth, a fine sieve or your preferred filter method.
- Store your infused oil or butter in an airtight container in a cool dark place.
- Enjoy as needed.

For further assistance or questions, please don't hesitate to contact our support team at support@thehippiehouse.com.au.

Happy infusing! 🌿