0

Your Cart is Empty

pH Meter + Buffer Solution Kit

LCD pH Meter + Buffer Solution Kit

Since pH value varies with temperature, this pH meter is equipped with Automatic Temperature Compensation (ATC), so you don’t need to worry about the effect of temperature change on pH level. pH value will be automatically adjusted in temperature between 0 – 50 °C (32 – 122 °F).

pH Meter + Buffer Solution Kit Includes:

  • 1 x pH meter
  • 2 x Calibration Solution (pH 4.003 & pH 6.864)(updated recently to powdered satchels - works the same)
  • 1 x Mini Screwdriver
  • 1 x Instruction Manual
  • 1 x Sturdy Plastic Case

pH Meter + Buffer Solution Kit Features:

  • High accuracy up to ±0.1 pH
  • Compact and portable pen-type design
  • Built with Automatic Temperature Compensation (ATC)
  • Batteries and Calibration Solution (pH 4.003 & pH 6.864) included

pH Meter + Buffer Solution Kit Specs:

  • PH measuring range : 0.00 – 14.00 pH
  • Resolution : 0.01 pH, 0.1 °C
  • Accuracy : ±0.1 pH, ±1 °C
  • Automatic Temperature Compensation : 0 – 50 °C (32 – 122 °F)
  • Operating Temperature : 0 – 50 °C (32 – 122 °F)
  • Power: 4 x 1.5V AG-13 Button Cell Batteries (included)
  • Duration: 500 hrs
  • Dimensions : approx. 150 x 27 x 20 mm (5.90′ x 1.06′ x 0.79′ inch)
  • Weight : approx. 95 g

Operating Information:

  • Remove the protective cap. First rinse the electrode with distilled water and absorb it with filter paper. Turn on pH by pressing the ON/OFF switch located at the top of the battery case. Immerse the pH meter electrode in the solution, only up to the immersion level. Under no circumstances should you immerse above the display level. Stir gently and wait for the reading to stabilize.
  • After use, switch it off and use distilled water to clean the electrode. Replace the protective cap.

PH CALIBRATION:

Immerse the electrode in pH 6.86 (under the temperature of 25°C) standard buffer solution of phosphate, and gently shake the electrode.

Regulate the trimmer with a screwdriver until the buffer solution value corresponding to the measurement temperature is obtained.

Immerse the electrode in pH 4.01 or pH9.18 the standard buffer solution of borax and wait about one minute, until the buffer solution value corresponding to the measurement temperature is obtained.